CHECKLIST OF Foldable Baby Travel Bed
Thoroughly review the legend on the left. We will use the legend in further steps of this instruction.
unfolding Travel Bed
Step 1: Open the packaging and take out the crib. Unfasten the mattress pad and remove the crib frame.
Step 2: Place the crib vertically on a flat surface. Pull up the side latches until you hear a "click" sound.
Step 3: Press down on the center of the crib bottom until it is level with the floor, indicating it is locked in place.
*Note: After unfolding, gently press down on all four side latches to ensure they are securely locked.
Installing the second-floor bed：
Step 1: As shown in the illustration, place the pipes of the bunk bed into the sockets on the backside of the bed frame.
Step 2: As shown in the illustration, put the bunk bed into the bed frame and attach the lifting chain, placing it into the frame.
*Note: Before using the crib, please carefully check that all sides are fully locked, ensure the mattress is securely placed, and verify that the base is locked in place.
Installation of the Storage Basket：
As shown in the diagram, first insert the hooks into the storage basket, and then attach the hooks on the storage basket to the bed frame handles.
Folded Instructions：
Step 1: Remove the second layer of the crib. Pull up on the releases located at the center base and press the buttons on the edges of the crib to unlock the sides.
Step 2: Once the four sides are unlocked and collapsed, fold the crib legs so they are all aligned and tucked together.
Step 3: After collapsing the crib, use the storage strap to tighten everything together. Place the folded crib into its carrying bag for easy transport.
Adjust the bed frame height：
Open the two side zippers on the armrest, pull apart the zipper, and lightly press both side buttons with your hands simultaneously so that the bed rail slides down and locks into place.
The bunk bed is supported by three brackets, with each section's height adjusted according to the corresponding zipper.
Note: You must press the buttons on both sides at the same time and simultaneously slide down to allow the smooth movement of the foldable side armrest.
Step 1：Position at the highest setting: Attach Link 1 to the bed rail in the middle.
Step 2：Position at the next highest setting: Attach Link 2 to the belt loop and hand pull.
Step 3：Position at the second setting: Attach Link 3 to the fabric loop and hand pull.
Step 4：Position at the third setting: Attach Link 1 to the loop and hand pull.
Connecting Adult Beds ：
Warning:When using a bedside sleeper attached to an adult bed, ensure the crib’s drop-down side is at its lowest position, and the height is lower than the adult bed to prevent a child from rolling off.
Slide the stabilizing board and connecting strap under the adult bed mattress, and secure the connecting strap on the other side of the adult bed with the board. Connect the strap’s buckle to the crib’s hook, ensuring the bedside sleeper is securely attached to the adult bed.
After securing the crib, push it by hand to ensure the gap between the crib and the adult bed does not exceed 0.5 inches. If the gap is larger, readjust the strap buckles.
Before using the crib, roll up and secure any extra lengths of the connecting strap. Always check that the connecting strap is tightened. It is recommended to adjust the strap’s length so it is shorter than the width of the adult bed, preventing any space between the crib and the bed.
Still Need Assistance?
Our knowledgeable and friendly representatives are here to assist you with any questions or concerns you may have. We understand that some problems may require a more personalized approach, and we are committed to ensuring your satisfaction.
